Search filter

Applications: Industrial seamless floors (1); Substrate preparation/Primers (1); Waterproofing coatings
Brands: Ardal (1); Eponal (1)
Destinations: ~~Floors~~ (2); Walls (1)
Specific characteristics: Exterior (1); Ready-to-use (1); Suitable on wet substrate; Water resistant (1)
Substrates: Ceramic tiles (1)
Segments: ~~Construction~~ (2)

Supertile

Acrylic tackifier adhesive for carpet tiles

Additional Downloads
MSDS (59 Kb)
Definitions
PrimerLiquid or paste applied onto a substrate to obtain optimum bonding. It helps regulate the porosity of the substrate (reduce absorption, therefore adhesive usage), increase adhesion to non porous surfaces, improves application properties of later on applied adhesive
TackAdhesive power to maintain together 2 materials. Tacky surface means sticky surface.

Uses

For bonding carpet tiles backed with PVC, polypropylene and bitumen with fibre backing onto concrete, cementitious screeds, raised access floors, asphalt, terrazzo, chipboard, plywood, smoothing compounds and existing PVC and lino.

This product is distributed by Al Nabooda interiors.

Benefits

Non staining
Permanently tacky film
Suitable for most carpet tiles
Easy to apply
Packaging in English

Properties

Physical:

Water based dispersion
Specific gravity : approx 1.0
Application temperature limits: 5°C - 40°C
Service temperature limits : up to 40°C

Consumption:

120-180m² per 15 L depending on porosity of subfloor and tile backing

Shelf life:

12 months under good storage in original, unopened containers. Keep out of direct sunlight, at a temperature of between 5°C and 40°C.

Application

All phases of the installation should comply with existing building standards.

Subfloor : Ensure the subfloor is clean, sound, dry and free from contaminants that may hinder adhesion, including surface hardeners and additives.The subfloor should be tested in accordance with building standards, using a properly calibrated and insulated hygrometer. A reading of 75% RH or less confirms that the subfloor is satisfactorily dry. Where this has not been attained, it is necessary to apply a surface membrane to suppress residual moisture. For further information contact Bostik Technical Service.

Smoothing compounds: Mechanically remove any surface treatments on concrete bases. Repair any deep indentations in the subfloor with a rapid repair mortar. When floor requires smoothing, apply a suitable smoothing compound at a minimum thickness of 3mm.

Existing floor coverings: Supertack is suitable for use over existing PVC and linoleum. Ensure all traces of polish and contaminants have been removed.

Priming: Clean surfaces thoroughly. Prime boards and other porous surfaces with suitable primer and allow to dry. This is particularly important with hardboard, chipboard and plywood. Ensure the manufacturer recommends the floor covering for use with the particular substrate.

APPLICATION
Apply using a soft brush, short haired lambswool (or mohair) roller or trowel over the entire floor area and allow to dry to a clear tacky film (normally 30-45 minutes at +15°C). Lay tiles and press firmly into position, ensuring no air is trapped. When removal of tiles is necessary, simply peel up from one corner.

Packaging

Presentation	Bar code	Bostik code
Plastick bucket - 15 litre(s)	5010591241985	000000