New Search > Ready-to-use > Environmentally friendly
Assembly and repair
(3)
Grab adhesives
(1)
Home decoration
(5)
Insulating Glass
(3)
Labelling
(5)
Parquet
(1)
Rigid packaging
(8)
Wall adhesives
(4)
Bostik
(18)
Quelyd
(6)
Floors
(1)
Walls
(4)
Environmentally friendly
Exterior
(2)
Heat resistant
(1)
Ready-to-use
Suitable on wet substrate
(3)
Water resistant
(1)
Paper/cardboard
(17)
PVC
(2)
Construction
(6)
Consumer
(5)
Industry
(16)
1-Component MS polymer-based parquet adhesive suitable for securing all types of parquet floorings on absorbent and impervious substrates. Moisture-resistant (e.g. bonding teak in wet areas). User-and environment-friendly (classified EC1 Very Low Emission). Permanently elastic at temperatures ranging from - 40° to +120°C. Restores its initial elasticity after compression or elongation.
It is used to apply labels on cold, wet, dry and hot, commercially available glass bottles. Suitable for low speed (< to 30 000 bottles/hour). Good flow characteristics.
It is used to apply labels on cold, wet, dry and hot, commercially available glass bottles. Suitable for high speed (up to 80 000 bottles/hour). Good flow characteristics. Good resistance to water condensation.
BLU TACK is the original re-usable adhesive that provides an ideal alternative to drawing pins and sticky tapes with hundred of uses around home, office and school environment. Suitable for: holding up posters, cards, paintings; holding down telephones, photographs in albums, calculator, wires; cleaning fluffs from fabric and dirt from keyboards.
High bond-strength for hanging all borders over any wallcovering, wallpaper and substrate. Easy Slide for quick border adjustability. Economic coverage. Extremely high tack: easy bonding and border positioning. Contains antifungal and biocide additives to prevent mould growth. Ideal for hanging in areas subject to condensation or wet areas (kitchen, bathroom). Packaging available in 4 languages: Romanian, Bulgarian, Ukranian, Russian.
Specifically formulated for use in the production of dual seal insulating glass units. Exhibits an extremely low moisture vapour transmission rate and excellent adhesion to glass, aluminium and galvanised steel spacer bar. Acts as a thermal break. Can also be used as a Spacer bar adhesive.
Single part butyl rubber based sealant. Compatible with all types of manual dispensing equipment currently available. Quick-setting from the molten state allowing units to be moved from their assembly location between two and five minutes after application. Can be used as a secondary seal in conjunction with a P.I.B.primary sealant.
Established market leading hot melt butyl edge sealant, specially developed for the edge sealing of factory produced insulating glass units by manual or robotic application. Sets quickly from its molten state, allowing untis to be moved from their assembly location within 5 minutes of application. Rapid unit production - smooth flow, fast gunning. Fully meets the requirement of EN 1279.
Long open time. Good tack. Standard application by double roller.
Good adhesion on difficult substrates (water ink or acrylic). Suitable for high and medium speed machines. Good initial tack at medium or high speed. Application by wheel.
