New Search > Floors
Home decoration
(20)
Industrial seamless floors
(8)
Parquet
(12)
Self-levelling compounds
(12)
Soft floor (carpet /PVC)
(18)
Substrate preparation/Primers
(11)
Tiling
(9)
Waterproofing coatings
(4)
Wood working
(1)
Ardal
(14)
Bostik
(22)
Eponal
(9)
Laybond
(1)
Novaflex
(2)
Quelyd
(1)
Roxol
(10)
Sader
(12)
Tarbicol
(4)
Floors
Walls
(11)
Environmentally friendly
(1)
Exterior
(8)
Heat resistant
(2)
Ready-to-use
(37)
Suitable on wet substrate
(2)
Water resistant
(5)
Ceramic tiles
(26)
PVC
(14)
Construction
(69)
Consumer
(3)
It can be applied in layers between 1-20 mm thickness in one work step. Thick layers and sloping finish possible by adding 0.4-0.9 mm sharp sand (i.e. in collective showers and kitchen). Quick hydraulic setting.
MSDS 1. Subfloor Preparation Guide (55 Ko) 2. Primers and self-levelling compounds (1642 Ko)
For smoothing and levelling of subfloors up to a maximum thickness of 50 mm in single work step. Can be used for smoothing walls up to 5 mm thickness. Can be used for local repairs at thickness greater than 30 mm, e.g. filling holes, depressions and cracks; repairing stairs and landings, building up sloping surfaces.
MSDS 1. Subfloor Preparation Guide (55 Ko) 2. Primers and self-levelling compounds (1642 Ko)
For smoothing and levelling of subfloors up to a maximum thickness of 5 mm in a single work step. Suitable for normal wear (plastic and textile coverings) in domestic/residential and light commercial locations. Does not shrink, very tolerant in renovation works.
Red-coloured to provide visual quality control. High resistance to indentation- Up to 10 mm in one work step. Reduced sanding.
Specially designed for renovation works in occupied locations. Dry for floor coverings after only 2-4 hours. Good mechanical and application qualities. Final finish in one step - no need to sand.
MSDS 1. Subfloor Preparation Guide (55 Ko) 2. Primers and self-levelling compounds (1642 Ko)
Suitable for smoothing and levelling of subfloors up to a maximum thickness of 15 mm in a single work step. For hard wear in commercial and industrial locations where service is only interrupted for few hours (hypermarkets and stores, hospitals, factories and workshops, public buildings). After only 4 hours the smoothed surface is ready for laying floor coverings. Can be used as a wearing surface.
1. Subfloor Preparation Guide (55 Ko) 2. Primers and self-levelling compounds (1642 Ko) MSDS (31 Ko)
Suitable for securing textiles and carpets with non-woven backings. Sprayable. Tiles can be lifted and replaced as required. Suitable onto absorbent and impervious substrates as well as existing floor coverings. High tack. Economical coverage.
Suitable for linoleum sheets, linoleum tiles with synthetic backing, cork-linoleum and cork underlayments. High initial adhesion strength.
It can be used for bonding PVC onto PVC, even in showers. High tack and immediate grab. Especially recommended for rigid and difficult coverings. Very tolerant to ambient conditions. Resistant to PVC flooring plasticiser.
Especially designed for use on building sites - excellent quality/price ratio. Low solvent content: <5%. High tack. Fast setting. Quickly set to traffic
