Physical:
- Adhesive type: modified starch-based adhesive in flakes
- Colour: tranclusent
- Paste preparation time: approx. 10 minutes
- Resistance to micro-organisms: very good, mould resistant formula
- Full cure: after 24-48 hours subject to ambient conditions, relative humidity and substrate porosity
- Yield per pack: approx. 35 m²
- Working temperature: between +10° and + 25°C
Consumption:
1 pack per 35 m²
Safety:
IMPORTANT: before embarking on any work involving QUELYD FLIZ the separate Product Safety Data Sheet must be studied carefully by those carrying out the work.
Observe good hygiene in use. Keep out of reach of children and animals. Avoid contact with eyes and skin.
Shelf life:
Keeps indefinitely in the unopened original packaging in a dry atmosphere. The prepared paste can keep for more than one week in a closed container in a frost-free place.
PREPARATION
Preparation should be in accordance with building standards. Walls must be sound, even, smooth, permanently dry and free from dust, grease or other contaminants, and have normal porosity.
Painted surfaces
Scrape off any flaking paint and smooth the surface with a sanding block. Glossy and semi-gloss paint as well as enamaled surfaces should be sanded to bring porosity to the substrate. Eliminate sanding dust. Rinse thouroughly.
Old wallpapers and wallcoverings
Remove old wallpaper and colour wash using DISSOUCOL Wallpaper Remover. Rinse thoroughly to get substrate perfectly clean.
Highly porous substrates should be primed. When hanging vinyl wallcoverings onto new or old substrates, we recommend to wash the walls thoroughly, then rinse with bleach and water solution.
ADHESIVE PREPARATION
Pour the required quantity of clean water into the bucket.
|
Wallcovering type
|
Cold water mix
|
Coverage
(sq.meters)
|
|
Wallcoverings with non-woven fabric backing
|
5 litres
|
35
|
|
Paintable wallcoverings with non-woven fabric backing
|
4.5 litres
|
30
|
Stir the water rapidly with a stick. Sprinkle the contents of one pack into water, mixing briskly for approximately 30 seconds. Leave for 10 minutes and stir thoroughly again. The adhesive is ready.
PASTING THE WALL
Using a medium-pile roller or a paste brush, paste the wall generously and regularly over a surface area slightly greater than the strip width. Make sure that adhesive is uniformly applied over the whole surface to be pasted. Using a brush paste thoroughly areas around skirtings.
HANGING WALLPAPER
Use a plumb line to make sure the first strip is perfectly straight. Hang the first strip. Gently slide the paper until the outer edge is lined up with the starting line.
Using a wallpaper brush, carefully press the wallpaper from the top downwards and from the centre toward the edges, taking care to roll out air bubbles and spread out any uneven patches of paste.
Mark a fold with the back of a scissors blade on the paper in the areas around windows and skirtings, than cut the strip with a cutting blade. Hang subsequent strips edge to edge with the previous one.
Flatten the joints according to manufacturer’s instructions. Immediately wipe off accidental splashes with a clean damp sponge.
Wait for at least 24 hours prior to painting the wallcoverings.
REMARKS
- Carefully read the hanging instructions and strictly follow the manufacturer's recommendations
- Do not start hanging wallcoverings from an outside corner
- This adhesive/wallcovering hanging method is not suitable for hanging wallpapers and paper-backed vinyls
Cleaning
Tools can be easily cleaned with warm water
Ardal
(8)
