Search filter

Applications: Heating, Ventilation & Air Conditioning (13); Industrial Assembly (4); Insulating Glass (4); Labelling (15); Rigid packaging (30); Sealants (2); Tapes and Labels (12); Wood working (13)
Brands: ~~Bostik~~ (95)
Specific characteristics: Environmentally friendly (32); Heat resistant (4); Ready-to-use (31); Suitable on wet substrate (3); Water resistant (8)
Substrates: Paper/cardboard (55)
Segments: Construction (2); ~~Industry~~ (95)

Extrafix

Multipurpose floor covering adhesive for internal use.

Additional Downloads
MSDS (60 Kb)
Definitions
PrimerLiquid or paste applied onto a substrate to obtain optimum bonding. It helps regulate the porosity of the substrate (reduce absorption, therefore adhesive usage), increase adhesion to non porous surfaces, improves application properties of later on applied adhesive
TackAdhesive power to maintain together 2 materials. Tacky surface means sticky surface.

Uses

For bonding most PVC sheet (including cushion types) and tiles as well as most carpets to most common substrates: concrete, sand / cement screeds, asphalt, wood, chipboard, plywood and smoothing compounds.

This product is distributed by Al Nabooda Interiors.

Benefits

Off-white dispersion with minimal odour
High tack in dry film
Versatile adhesive
Minimal odour

Properties

Physical:

Water borne, containing some aromatic hydrocarbon
Non flammable
Approx. specific gravity : 1.18
Application temperature limits : +5 to +40°C
Service temperature limits : up to +40°C
Application temperature limits: 5°C - 40°C

Consumption:

40 - 50 m² per 15 kg

Shelf life:

12 months under good storage conditions in original, unopened containers. Keep out of direct sunlight, at a temperature between 5°C and 40°C.

Application

All phases of the installation should comply with existing building standards.

Subfloor: Ensure the subfloor is clean, sound, dry and free from contaminants that may hinder adhesion, including surface hardeners and additives. The subfloor should be tested using a properly calibrated and insulated hygrometer. A reading of 75% RH or less confirms that the subfloor is satisfactorily dry. Where this has not been attained, it is necessary to apply a surface membrane to suppress residual moisture. For further information contact Bostik Technical Service.

Smoothing compounds: Mechanically remove any surface treatments on concrete bases. Repair any deep indentations in the subfloor with a rapid repair mortar. When floor requires smoothing, apply a suitable smoothing compound at a minimum thickness of 3mm.

Existing floor coverings: Bonding over existing floor coverings should be avoided wherever possible as results cannot be guaranteed. For situations where the floor covering cannot be removed, contact Bostik Technical Service.

Priming: Clean surfaces thoroughly. Prime boards and other porous surfaces with suitable primer and allow to dry. This is particularly important with hardboard, chipboard and plywood. Ensure the manufacturer recommends the floor covering for use with the particular substrate.

APPLICATION
Porous surfaces:
Using a triangular-notched trowel (1.5mm deep at 5mm centres), spread adhesive evenly over substrate with a sweeping motion at a 60° angle. After approx. 15 minutes (adhesive still wet), the floor covering may be placed into position then apply even pressure to ensure good overall contact. For embossed floor coverings increase trowel notch size (2mm deep at 6mm centres).

Non / Low-porous surfaces:
It is recommended to apply a suitable smoothing compound to a minimum depth of 3mm and allow to dry overnight. Proceed as for porous surfaces.

Packaging

Presentation	Bar code	Bostik code
Plastic bucket - 15 kg	5010591241992	000000